The DCD1 servo drive is ideal for driving DC servomotors (direct current), equipped with a speed transducer, with voltages up to 260V and maximum currents up to 50A.
The DCD1 has internal analog circuits with IGBT bridge, operation in the 4 quadrants, without zero play.
Settings are made with trimmer and test point; diagnostics via green and red LEDs.
Further information
Technical data
Matching motors
Matching transducers
Special functions
Accessories
Maximum output voltage: 260Vac
Maximum output current: from 6A to 50A
- D.c. motors (direct current) with speed transducer.
- TTL 5V Encoder Line Driver.
- D.c.tachometer.
- For other types of transducers, contact ALTER technical department.
NOTE: when ordering specify the type of transducer.
- Differential input for speed reference
- Ramp on the adjustable speed signal and can be excluded
- Analog input for external setting of the current limit
- Analog output proportional to the motor speed
- Analog output proportional to the motor current
- Opto-isolated logic commands: 15-30Vdc 10mA max
- L.E.D. indicating the operating status and the alarms
- Digital input to perform "Reset memorized alarms" from the drive
- Signaling of "Working drive" with NO contact. of relay
- "Simulated Encoder" output 1024 pulses / revolution 5V line driver (not with brushless motor equipped with tachometer)
- Three-phase mains inductance
- Three-phase line filter
- External fuse holder
- Ultrafast fuses
- External braking resistor
- Capacitive module for DC-BUS
